[U-Boot] [PATCH v2 1/4] ehci-omap: Clean up added ehci-omap.c

[Marek Vasut]

> On Wed, Jan 11, 2012 at 4:22 PM, Marek Vasut <marek.vasut at gmail.com> wrote:
> >> Hi Marek,
> >> 
> >> Thanks for you review.
> >> 
> >> On Tue, Jan 10, 2012 at 9:37 PM, Marek Vasut <marek.vasut at gmail.com> wrote:
> >> >> From: "Govindraj.R" <govindraj.raja at ti.com>
> >> >> 
> >> >> Clean up added ehci-omap.c and make it generic for re-use across
> >> >> soc having same ehci ip block. Also pass the modes to be configured
> >> >> and configure the ports accordingly. All usb layers are not cache
> >> >> aligned till then keep cache off for usb ops as ehci will use
> >> >> internally dma for all usb ops.
> >> >> 
> >> >> * Add a generic common header ehci-omap.h having common ip block
> >> >>   data and reg shifts.
> >> >> * Rename and modify ehci-omap3 to ehci.h retain only conflicting
> >> >>   sysc reg shifts remove others and move to common header file.
> >> > 
> >> > Don't reimplement the ulpi stuff ... there's already some ulpi stuff
> >> > in uboot that needs fixing, so fix it and use it.
> >> 
> >> I am not implementing any ulpi stuff I am just configuring OMAP on
> >> soc usb host controller (ehci). All the configuration stuff
> >> is OMAP specific things which are done in ehci-omap.c file
> >> 
> >> stuffs done are like soft-reset, port mode to be used and putting
> >> port in no -idle mode(omap specific pm implementation) etc.
> > 
> > This stuff:
> > 
> > +/* ULPI */
> > +#define ULPI_SET(a)                                    (a + 1)
> > +#define ULPI_CLR(a)                                    (a + 2)
> > +#define ULPI_FUNC_CTRL                                 0x04
> > +#define ULPI_FUNC_CTRL_RESET                           (1 << 5)
> > 
> > is just accidentally conforming to ULPI spec?
> 
> These are for configuring INSNREG05_ULPI reg in EHCI reg map
> of omap while configuring in ulpi-phy mode.
> 
> looking into struct ulpi_regs {..}
> then it doesn't map this configuration.

Can you point me to some documentation about this please? It's not that I don't 
trust you, I'd rather prefer to avoid unnecessary duplication.

> 
> btw,
> IIUC that ulpi_regs struct is for otg transceiver that uses a ulpi phy chip
> for communication.
> 
> > M
> 
> > btw. somewhere in the patch is one more asterisk at the end of line:
> Will check that

It was on the line I pointed out 
> 
> --
> Thanks,
> Govindraj.R