[U-Boot] [PATCH 1/2 V2] arm926: Flush the data cache before disabling it.

[Sughosh Ganu]

hi Christian,

On Mon Jan 30, 2012 at 09:10:46AM +0100, Christian Riesch wrote:

<snip>

> >> Perhaps we should revert that change and instead remove
> >> CONFIG_SKIP_LOWLEVEL_INIT from the da850 board config files. But since
> >> we don't need the lowlevel_init function for DA850 SoCs we must either
> >> add a dummy function or add some additional defines that allow
> >> removing the CONFIG_SKIP_LOWLEVEL_INIT define without calling
> >> lowlevel_init. Any suggestions how such defines should be called or
> >> how the logic behind them should be so it doesn't cause breakage of
> >> existing boards?
> >
> > or we should introduce a "CONFIG_SKIP_CPU_CRIT_INIT" define, which
> > if defined, prevent the jump to cpu_init_crit ... so we have the same
> > behaviour as before commit "ca4b55800ed74207c35271bf7335a092d4955416"
> >
> > Boards which have problems with cpu_crit_init, should define
> > this new define ... but it would be better to find out, what
> > is really going on here ...
> 
> Yes, that would be good of course.
> 
> Another idea: Actually the init code that we are discussing here is
> executed twice. First in the SPL and then in the full-blown u-boot.
> Sughosh, are you sure it is the execution of the code in SPL that causes
> the trouble? I'm asking since we don't do any memory barrier related stuff
> in the code that loads u-boot from flash in SPL. Of course, dcache is off
> but icache is on.

  Yes, it is the spl that is executing the code. There is a spl
  specific string that gets displayed on the console, before spl goes
  on to load the u-boot image and jump to it, and i don't see that
  string on the console.

-sughosh