[U-Boot] [PATCH v2 03/14] arm/km: convert mgcoge3un target to km_kirkwood

[Prafulla Wadaskar]

> -----Original Message-----
> From: Wolfgang Denk [mailto:wd at denx.de]
> Sent: 03 July 2012 23:31
> To: Prafulla Wadaskar
> Cc: Holger Brunck; u-boot at lists.denx.de; Valentin Longchamp
> Subject: Re: [U-Boot] [PATCH v2 03/14] arm/km: convert mgcoge3un
> target to km_kirkwood
> 
> Dear Prafulla,
> 
> In message <F766E4F80769BD478052FB6533FA745D1A2FE3028D at SC-
> VEXCH4.marvell.com> you wrote:
> >
> > Do you think I should pull this patch series, I hope it applies
> cleanly on the recent master branch.
> > Please confirm.
> 
> I have to admit that I neither reviewed the patches in question, nor
> did I follow the whole thread of communication in this patch series.
> But the general rule is that if there are no strong argumentents
> against a patch (like a clear NAK or a specific request for changes)
> we will apply it.

Hi Wolfgang,
This patch series was too old, I was trying to save my effors ;-D
Finally I pulled these patches and tried to apply, but as I doubted it failed :-(
 
Hi Hogler

I could not apply the said patch series to the latest u-boot-marvell.git master branch

Pls re-submit it.

git-am U-Boot-1-9-arm-km-add-board-type-to-boards.cfg.patch

Applying arm/km: add board type to boards.cfg

error: patch failed: boards.cfg:138
error: boards.cfg: patch does not apply
error: patch failed: include/configs/km_kirkwood.h:42
error: include/configs/km_kirkwood.h: patch does not apply
Patch failed at 0001.
When you have resolved this problem run "git-am --resolved".
If you would prefer to skip this patch, instead run "git-am --skip"

Regards..
Prafulla . . .