[U-Boot] [PATCH v2 03/14] arm/km: convert mgcoge3un target to km_kirkwood

[Holger Brunck]

On 07/05/2012 03:48 PM, Prafulla Wadaskar wrote:
>>
>> And if I resend the remaining eleven patches in the same order as
>> beneath
>> these are:
>> [U-Boot,v2,01/14] arm/km: add kmnusa board support
>> [U-Boot,v2,02/14] arm/km: add kmcoge5un board support
>> [U-Boot,v2,03/14] arm/km: convert mgcoge3un target to km_kirkwood
>> [U-Boot,v2,04/14] arm/km: remove portl2.h and use km_kirkwood instead
>> [U-Boot,v2,06/14] arm/km: enable BOCO2 FPGA download support
>> [U-Boot,v2,07/14] arm/km: cleanup km_kirkwood boards
>> [U-Boot,v2,08/14] arm/km: redefine piggy 4 reg names to avoid
>> conflicts
>> [U-Boot,v2,11/14] arm/km: skip FPGA config when already configured
>> [U-Boot,v2,12/14] arm/km: support the 2 PCIe fpga resets
>> [U-Boot,v2,13/14] arm/km: add implementation for read_dip_switch
>> [U-Boot,v2,14/14] arm/km: remove calls to kw_gpio_* in
>> board_early_init_f
>>
>> as another patch serie do you accept this?
> 
> YES.
> 

ok done.

Unfortunately after sending v3 I saw that already in v2 I introduced a bug
during renaming the kwbimage.cfg in the first patch. I already sent a patch wich
corrected this as a v4. But only this patch as v4 because the other ten patches
don't need to be changed, because  of this.

Regards
Holger