[U-Boot] [PATCH v4] arm/km: add kmnusa board support

[Prafulla Wadaskar]

> -----Original Message-----
> From: Holger Brunck [mailto:holger.brunck at keymile.com]
> Sent: 05 July 2012 21:08
> To: u-boot at lists.denx.de
> Cc: Holger Brunck; Valentin Longchamp; Gerlando Falauto; Prafulla
> Wadaskar
> Subject: [PATCH v4] arm/km: add kmnusa board support
> 
> This board is similar to portl2, but it has the u-boot environment
> in a SPI NOR flash and not in an i2c eeprom like portl2 have.
> 
> Some other details:
>  - IVM EEPROM is at adress: pca9547:70:9
>  - PCI is enabled
>  - PIGGY4 is connected via MV88E6352 simple switch. There is no phy
>    between the simple switch and the kirkwood.
> 
> Signed-off-by: Holger Brunck <holger.brunck at keymile.com>
> Signed-off-by: Valentin Longchamp <valentin.longchamp at keymile.com>
> cc: Gerlando Falauto <gerlando.falauto at keymile.com>
> cc: Prafulla Wadaskar <prafulla at marvell.com>
> ---
> changes for v4:
>   - the wrong kwbimage_128M16_1.cfg file was picked up
>     this was already present in v2 due to the renaming issue
>     now fixed
> changes for v3:
>   - rebase to current master
>   - use reset_phy funtion as on mgcoge3un
> changes for v2:
>   - rename 128M16-1.cfg to kwbimage_128M16_1.cfg
> 


Applied this patch to u-boot-marvell.git master branch

Regards...
Prafulla . . .