[U-Boot] pull request for u-boot-tegra/master

[Tom Warren]

Albert,

Please pull u-boot-tegra/master into ARM master. Thanks!

The following changes since commit 58e22f8a15adec39d24d060180d76a4cbe86a04b:
  Stephen Warren (1):
        fdt: send all dtc output to stderr

are available in the git repository at:

  git://git.denx.de/u-boot-tegra master

Jim Lin (1):
      tegra: usb: Fix device enumeration problem of USB1

Lucas Stach (2):
      tegra: add ULPI on USB2 funcmux entry
      tegra: usb: fix wrong error check

Stephen Warren (10):
      Add env vars describing U-Boot target board
      tegra: enable CONFIG_ENV_VARS_UBOOT_CONFIG
      tegra: add enterrcm command
      tegra: bootcmd enhancements
      tegra: bootcmd: start USB only when needed
      tegra: add GMC/GMD funcmux entry for SFLASH
      tegra: add pin_mux_spi() board initialization function
      tegra: trimslice: set up serial flash pinmux
      tegra: enable bootz command
      tegra: define fdt_load/fdt_high variables

Thierry Reding (7):
      tegra: Rework Tamonten support
      tegra: medcom: Add device tree support
      tegra: plutux: Add device tree support
      tegra: Allow boards to perform early GPIO setup
      tegra: Implement gpio_early_init() on Tamonten
      tegra: Use SD write-protect GPIO on Tamonten
      tegra: Add Tamonten Evaluation Carrier support

Tom Warren (1):
      tegra: fix leftover CONFIG_TEGRA2_MMC & _SPI build switches

 MAINTAINERS                                |    1 +
 README                                     |   14 ++++
 arch/arm/cpu/armv7/tegra2/Makefile         |    1 +
 arch/arm/cpu/armv7/tegra2/cmd_enterrcm.c   |   65 +++++++++++++++++++
 arch/arm/cpu/armv7/tegra2/funcmux.c        |   23 ++++++-
 arch/arm/cpu/armv7/tegra2/usb.c            |    2 +-
 arch/arm/include/asm/arch-tegra2/funcmux.h |    6 ++
 arch/arm/include/asm/arch-tegra2/tegra2.h  |    1 +
 board/avionic-design/common/tamonten.c     |   65 ++++++-------------
 board/avionic-design/common/tamonten.h     |   32 ---------
 board/avionic-design/dts/tegra2-medcom.dts |   58 +++++++++++++++++
 board/avionic-design/dts/tegra2-plutux.dts |   58 +++++++++++++++++
 board/avionic-design/dts/tegra2-tec.dts    |   58 +++++++++++++++++
 board/avionic-design/medcom/Makefile       |    6 +-
 board/avionic-design/medcom/medcom.c       |   45 -------------
 board/avionic-design/plutux/Makefile       |    6 +-
 board/avionic-design/plutux/plutux.c       |   45 -------------
 board/avionic-design/tec/Makefile          |   50 ++++++++++++++
 board/compal/paz00/paz00.c                 |    4 +-
 board/compulab/trimslice/trimslice.c       |    7 ++-
 board/nvidia/common/board.c                |   16 ++++-
 board/nvidia/common/board.h                |    1 +
 boards.cfg                                 |    1 +
 common/env_common.c                        |   11 +++
 common/env_embedded.c                      |   11 +++
 drivers/usb/host/ehci-tegra.c              |   18 +++++-
 include/configs/medcom.h                   |   21 ++++++-
 include/configs/plutux.h                   |   21 ++++++-
 include/configs/tec.h                      |   82 ++++++++++++++++++++++++
 include/configs/tegra2-common-post.h       |   96 ++++++++++++++++++---------
 include/configs/tegra2-common.h            |    3 +
 mkconfig                                   |    8 ++
 32 files changed, 622 insertions(+), 214 deletions(-)
 create mode 100644 arch/arm/cpu/armv7/tegra2/cmd_enterrcm.c
 delete mode 100644 board/avionic-design/common/tamonten.h
 create mode 100644 board/avionic-design/dts/tegra2-medcom.dts
 create mode 100644 board/avionic-design/dts/tegra2-plutux.dts
 create mode 100644 board/avionic-design/dts/tegra2-tec.dts
 delete mode 100644 board/avionic-design/medcom/medcom.c
 delete mode 100644 board/avionic-design/plutux/plutux.c
 create mode 100644 board/avionic-design/tec/Makefile
 create mode 100644 include/configs/tec.h