[U-Boot] Ethernet on PandaBoard

[Gary Thomas]

I just tried rev 211e47549b668c7cdd8658c0413a272f0d0495d4 (v2012.07-rc1)
for my PandaBoard.  Sadly, this is failing when I try to use the onboard
ethernet (EHCI USB based) controller:

U-Boot SPL 2012.07-rc1 (Jul 11 2012 - 06:56:00)
OMAP4430 ES2.2
OMAP SD/MMC: 0
reading u-boot.img
reading u-boot.img


U-Boot 2012.07-rc1 (Jul 11 2012 - 06:56:00)

CPU  : OMAP4430 ES2.2
Board: OMAP4 Panda
I2C:   ready
DRAM:  1 GiB
MMC:   OMAP SD/MMC: 0
Using default environment

In:    serial
Out:   serial
Err:   serial
Net:   No ethernet found.
Hit any key to stop autoboot:  0
Panda # usb start
(Re)start USB...
USB:   Register 1313 NbrPorts 3
data abort
pc : [<bff9acb0>]          lr : [<bff9ac91>]
sp : bff08e28  ip : 0000000f     fp : 00000000
r10: bff0a370  r9 : 00000002     r8 : bff08f68
r7 : bffbb070  r6 : 00000000     r5 : bffaee04  r4 : 00001313
r3 : bffaee04  r2 : 98000000     r1 : 0000000a  r0 : 00000019
Flags: Nzcv  IRQs off  FIQs off  Mode SVC_32
Resetting CPU ...

Anyone else see this?  Ideas?

How do I map these addresses (PC=0xbff9acb0) to the ones in my
u-boot ELF image (so I can figure out what went wrong)?

Thanks

-- 
------------------------------------------------------------
Gary Thomas                 |  Consulting for the
MLB Associates              |    Embedded world
------------------------------------------------------------