[U-Boot] Ethernet on PandaBoard

[Gary Thomas]

On 2012-07-12 07:27, Gary Thomas wrote:
> On 2012-07-12 07:20, Tom Rini wrote:
>> On Thu, Jul 12, 2012 at 07:17:59AM -0600, Gary Thomas wrote:
>>> On 2012-07-12 07:15, Tom Rini wrote:
>>>> On Thu, Jul 12, 2012 at 07:06:02AM -0600, Gary Thomas wrote:
>>>>> On 2012-07-12 03:30, Tom Rini wrote:
>>>>>> On Thu, Jul 12, 2012 at 02:20:18AM -0700, Tom Rini wrote:
>>>>>>> On Wed, Jul 11, 2012 at 07:08:50AM -0600, Gary Thomas wrote:
>>>>>>>
>>>>>>>> I just tried rev 211e47549b668c7cdd8658c0413a272f0d0495d4 (v2012.07-rc1)
>>>>>>>> for my PandaBoard.  Sadly, this is failing when I try to use the onboard
>>>>>>>> ethernet (EHCI USB based) controller:
>>>>>>>
>>>>>>> Sorry for the late response, at a conference.  This is a known problem
>>>>>>> and we will either have this fixed soon (Ilya Yanok is working on a
>>>>>>> series) or we will build-time disable dcache support on these boards and
>>>>>>> fix this properly for the next release.
>>>>>>>
>>>>>>> In short, some cache clean-ups in ehci-hcd.c exposed other cache
>>>>>>> problems on other platforms where our cache size is 64 not 32bytes.
>>>>>>
>>>>>> I take it back, I forgot omap4 is 32byte cache.  With the fix that
>>>>>> Tetsuyuki Kobayashi pointed you at (oh, and a Tested-by to that thread
>>>>>> if you can), can you please do a little stress testing of USB, to make
>>>>>> sure things are otherwise really happy (eth and perhaps a USB stick)?
>>>>>> Thanks alot!
>>>>>>
>>>>>
>>>>> Yesterday, this was working great.  This morning, when I turned on
>>>>> the board, it can no longer find anything on the USB bus - nothing at
>>>>> all.  This also applies to Linux when I boot from SD.  I'm really
>>>>> confused :-(
>>>>>
>>>>> If I boot the board using the 2011.06 U-Boot, all is happy again.
>>>>> It looks like the USB HUB (USB3320) seems to be stuck in reset when
>>>>> I use the latest U-Boot.
>>>>>
>>>>> Ever hear of any problems like this?
>>>>
>>>> How about if you turn the dcache off at run or build time?
>>>>
>>>
>>> Sorry for being thick, but how do I do that?  I don't see any
>>> cache manipulation commands in 'help'
>>
>> Looks like omap4 doesn't have CONFIG_CMD_CACHE set, so indeed you're
>> missing 'dcache off' as a command.  The other one is to add
>> CONFIG_SYS_DCACHE_OFF to omap4_panda.h (or omap4_common.h) and rebuild.
>>
>
> No difference, sorry.
>

After some poking around, I found that the GPIO pins used by the USB
(GPIO_1 = hub power, GPIO_62 = hub reset) were not muxed at all.  This
left those signals (and many others) in strange limbo.

Adding CONFIG_SYS_ENABLE_PADS_ALL brought it back to life and the network
is working once more.

-- 
------------------------------------------------------------
Gary Thomas                 |  Consulting for the
MLB Associates              |    Embedded world
------------------------------------------------------------