[U-Boot] Building u-boot for iMX28 and getting error in mkimage of missing command line parameter CONFIG_IMX_CONFIG

[Bill]

Thanks.  That did it!


However, now my new U-boot built from the mainstream Uboot runs and also 
loads and unpacks the Linux kernel - but it dies after that.  However, 
my original U-boot from tlib works fine.  Are there some patches and/or 
settings I am missing?

Thanks,

Bills



On 7/26/2012 3:24 PM, Fabio Estevam wrote:
> Bill,
>
> On Thu, Jul 26, 2012 at 3:28 PM, Bill<bsousan at techsi.com>  wrote:
>> All,
>>
>>      I am working on building the latest u-boot for the imx28evk board.  I
>> have done the following steps:
>>
>> 1. git clone git://git.denx.de/u-boot-imx.git
>> 2. setup paths for finding my cross-compiler
>> 1.  make mx28evk_config
>> 2.  make u-boot.imx
> 'make u-boot.imx'  is not correct for mx28.
>
> You should do:
>
> make u-boot.sb
>
> Please follow the instructions at doc/README.mx28_common for the
> correct process.
>
> Regards,
>
> Fabio Estevam

-- 
William (Bill) L. Sousan, Ph.D.
(w) 402.331.4977 ext. 4002
bsousan at techsi.com
Technical Support Inc.
11253 John Galt Blvd
Omaha, NE 68137
www.techsi.com
8(a) SDB Certified, ISO 9001:2008