[U-Boot] [PATCH 2/2] tegra: bootcmd: start USB only when needed

[Stephen Warren]

From: Stephen Warren <swarren at nvidia.com>

Instead of initializing USB as soon as bootcmd is executed, defer it
until the first boot device that (potentially in the case of network)
uses USB is scanned. This avoids initializing USB when booting from MMC,
so speeds that up.

Signed-off-by: Stephen Warren <swarren at nvidia.com>
---
 include/configs/tegra2-common-post.h |   14 +++++++++++---
 1 files changed, 11 insertions(+), 3 deletions(-)

diff --git a/include/configs/tegra2-common-post.h b/include/configs/tegra2-common-post.h
index 85b037c..80d9c35 100644
--- a/include/configs/tegra2-common-post.h
+++ b/include/configs/tegra2-common-post.h
@@ -58,24 +58,33 @@
 #endif
 
 #ifdef CONFIG_CMD_USB
+#define BOOTCMD_INIT_USB "run usb_init; "
 #define BOOTCMDS_USB \
+	"usb_init=" \
+		"if ${usb_need_init}; then " \
+			"set usb_need_init false; " \
+			"usb start 0; " \
+		"fi\0" \
+	\
 	"usb_boot=" \
 		"setenv devtype usb; " \
+		BOOTCMD_INIT_USB \
 		"if usb dev ${devnum}; then " \
 			"run scan_boot; " \
 		"fi\0" \
+	\
 	"bootcmd_usb0=setenv devnum 0; run usb_boot;\0"
 #define BOOT_TARGETS_USB "usb0"
-#define BOOTCMD_INIT_USB "usb start 0; "
 #else
+#define BOOTCMD_INIT_USB ""
 #define BOOTCMDS_USB ""
 #define BOOT_TARGETS_USB ""
-#define BOOTCMD_INIT_USB ""
 #endif
 
 #ifdef CONFIG_CMD_DHCP
 #define BOOTCMDS_DHCP \
 	"bootcmd_dhcp=" \
+		BOOTCMD_INIT_USB \
 		"if dhcp ${scriptaddr} boot.scr.uimg; then "\
 			"source ${scriptaddr}; " \
 		"fi\0"
@@ -127,7 +136,6 @@
 	BOOTCMDS_DHCP
 
 #define CONFIG_BOOTCOMMAND \
-	BOOTCMD_INIT_USB \
 	"for target in ${boot_targets}; do run bootcmd_${target}; done"
 
 #endif
-- 
1.7.0.4