[U-Boot] [PATCH 6/7] da850/omap-l138: Add support for NAND SPL

[Lad, Prabhakar]

Hi Christian, 

On Tue, Jun 05, 2012 at 16:56:01, Christian Riesch wrote:
> Hi,
> 
> On Fri, Jun 1, 2012 at 4:30 PM, Prabhakar Lad <prabhakar.lad at ti.com> wrote:
> > From: Lad, Prabhakar <prabhakar.lad at ti.com>
> >
> > This patch adds support for NAND SPL on DA850/OMAP-L138.
> >
> > Signed-off-by: Lad, Prabhakar <prabhakar.lad at ti.com>
> > Signed-off-by: Rajashekhara, Sudhakar <sudhakar.raj at ti.com>
> > Signed-off-by: Hadli, Manjunath <manjunath.hadli at ti.com>
> > ---
> >  arch/arm/cpu/arm926ejs/davinci/spl.c |   13 ++++++-----
> >  include/configs/da850evm.h           |   39 +++++++++++++++++++++++++++++----
> >  2 files changed, 41 insertions(+), 11 deletions(-)
> >
> > diff --git a/arch/arm/cpu/arm926ejs/davinci/spl.c b/arch/arm/cpu/arm926ejs/davinci/spl.c
> > index be397ce..53df581 100644
> > --- a/arch/arm/cpu/arm926ejs/davinci/spl.c
> > +++ b/arch/arm/cpu/arm926ejs/davinci/spl.c
> > @@ -79,12 +79,6 @@ void board_init_f(ulong dummy)
> >
> >  void board_init_r(gd_t *id, ulong dummy)
> >  {
> > -#ifdef CONFIG_SPL_NAND_LOAD
> > -       nand_init();
> > -       puts("Nand boot...\n");
> > -       nand_boot();
> > -#endif
> > -#ifdef CONFIG_SPL_SPI_LOAD
> >        mem_malloc_init(CONFIG_SYS_TEXT_BASE - CONFIG_SYS_MALLOC_LEN,
> >                        CONFIG_SYS_MALLOC_LEN);
> >
> > @@ -95,6 +89,13 @@ void board_init_r(gd_t *id, ulong dummy)
> >        serial_init();          /* serial communications setup */
> >        gd->have_console = 1;
> >
> 
> This breaks the build for the cam_enc_4xx board and the hawkboard.
> 
> You may do this initializations only if CONFIG_SPL_LIBCOMMON_SUPPORT
> is defined. Please test your patchset with ./MAKEALL -s davinci
> 
  Ok I'll fix this.

Thx,
--Prabhakar Lad

> Regards, Christian
> 
> > +#ifdef CONFIG_SPL_NAND_LOAD
> > +       puts("Nand boot...\n");
> > +       nand_init();
> > +       puts("Nand Initalized...\n");
> > +       nand_boot();
> > +#endif
> > +#ifdef CONFIG_SPL_SPI_LOAD
> >        puts("SPI boot...\n");
> >  #ifdef CONFIG_SPL_MMC_LOAD
> >        spl_mmc_load();
> 
> [...]
>