[U-Boot] [PATCH 1/6] imx31_phycore: Remove CONFIG_SYS_I2C_SLAVE definition

Stefano Babic sbabic at denx.de
Fri Jun 15 16:43:31 CEST 2012


On 03/06/2012 09:53, Fabio Estevam wrote:
> From: Fabio Estevam <fabio.estevam at freescale.com>
> 
> According to include/i2c.h:
> 
> "/*
>  * Many boards/controllers/drivers don't support an I2C slave interface so
>  * provide a default slave address for them for use in common code.  A real
>  * value for CONFIG_SYS_I2C_SLAVE should be defined for any board which does
>  * support a slave interface.
>  */
> #ifndef	CONFIG_SYS_I2C_SLAVE
> #define	CONFIG_SYS_I2C_SLAVE	0xfe
> #endif

Whole series applied to u-boot-imx, thanks.

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================


More information about the U-Boot mailing list