[U-Boot] [PATCH v3 4/9] arm, davinci: perform check for initalizing global data and serial init

Prabhakar Lad prabhakar.lad at ti.com
Thu Jun 21 09:51:26 CEST 2012


From: Lad, Prabhakar <prabhakar.lad at ti.com>

initialize baudrate, flags, data and serial intialization,
only when CONFIG_SPL_LIBCOMMON_SUPPORT is defined.

Signed-off-by: Lad, Prabhakar <prabhakar.lad at ti.com>
Signed-off-by: Rajashekhara, Sudhakar <sudhakar.raj at ti.com>
Signed-off-by: Hadli, Manjunath <manjunath.hadli at ti.com>
---
 Chnages for v3:
 1: Creted new patch by splitting patch 6 of v2, to make 
    it more readable.

 arch/arm/cpu/arm926ejs/davinci/spl.c |   15 +++++++++------
 1 files changed, 9 insertions(+), 6 deletions(-)

diff --git a/arch/arm/cpu/arm926ejs/davinci/spl.c b/arch/arm/cpu/arm926ejs/davinci/spl.c
index 74632e5..7d9b289 100644
--- a/arch/arm/cpu/arm926ejs/davinci/spl.c
+++ b/arch/arm/cpu/arm926ejs/davinci/spl.c
@@ -74,12 +74,7 @@ void board_init_f(ulong dummy)
 
 void board_init_r(gd_t *id, ulong dummy)
 {
-#ifdef CONFIG_SPL_NAND_LOAD
-	nand_init();
-	puts("Nand boot...\n");
-	nand_boot();
-#endif
-#ifdef CONFIG_SPL_SPI_LOAD
+#ifdef CONFIG_SPL_LIBCOMMON_SUPPORT
 	mem_malloc_init(CONFIG_SYS_TEXT_BASE - CONFIG_SYS_MALLOC_LEN,
 			CONFIG_SYS_MALLOC_LEN);
 
@@ -90,6 +85,14 @@ void board_init_r(gd_t *id, ulong dummy)
 	serial_init();          /* serial communications setup */
 	gd->have_console = 1;
 
+#endif
+
+#ifdef CONFIG_SPL_NAND_LOAD
+	nand_init();
+	puts("Nand boot...\n");
+	nand_boot();
+#endif
+#ifdef CONFIG_SPL_SPI_LOAD
 	puts("SPI boot...\n");
 	spi_boot();
 #endif
-- 
1.7.4.1



More information about the U-Boot mailing list