[U-Boot] [PATCH v4 11/13] tegra20: move SDRAM param save to later in boot

[Allen Martin]

Move warmboot_save_sdram_params() to later in the boot sequence.  This
code relies on devicetree to get the address of the memory controller
and with upcoming changes for SPL boot it gets called early in the
boot process when devicetree is not initialized yet.

Signed-off-by: Allen Martin <amartin at nvidia.com>
---
 arch/arm/cpu/tegra20-common/ap20.c |    5 -----
 board/nvidia/common/board.c        |    3 +++
 2 files changed, 3 insertions(+), 5 deletions(-)

diff --git a/arch/arm/cpu/tegra20-common/ap20.c b/arch/arm/cpu/tegra20-common/ap20.c
index 8b6afbc..6ff71e0 100644
--- a/arch/arm/cpu/tegra20-common/ap20.c
+++ b/arch/arm/cpu/tegra20-common/ap20.c
@@ -345,11 +345,6 @@ void init_pmc_scratch(void)
 	/* ODMDATA is for kernel use to determine RAM size, LP config, etc. */
 	odmdata = get_odmdata();
 	writel(odmdata, &pmc->pmc_scratch20);
-
-#ifdef CONFIG_TEGRA20_LP0
-	/* save Sdram params to PMC 2, 4, and 24 for WB0 */
-	warmboot_save_sdram_params();
-#endif
 }
 
 void tegra20_start(void)
diff --git a/board/nvidia/common/board.c b/board/nvidia/common/board.c
index f349243..03f629d 100644
--- a/board/nvidia/common/board.c
+++ b/board/nvidia/common/board.c
@@ -126,6 +126,9 @@ int board_init(void)
 #endif
 
 #ifdef CONFIG_TEGRA20_LP0
+	/* save Sdram params to PMC 2, 4, and 24 for WB0 */
+	warmboot_save_sdram_params();
+
 	/* prepare the WB code to LP0 location */
 	warmboot_prepare_code(TEGRA_LP0_ADDR, TEGRA_LP0_SIZE);
 #endif
-- 
1.7.9.5