[U-Boot] [PATCH 2/3] SPEAr: Configure FSMC driver for NAND interface

[Stefan Roese]

Hi Scott,

On Wednesday 29 February 2012 19:03:20 Scott Wood wrote:
> >>> You also need the following define for this to work with the latest
> >>> NAND subsystem:
> >>> 
> >>> #define CONFIG_MTD_ECC_SOFT
> >>> 
> >>> Not sure about SPEAr3xx. Most likely this needs it as well.
> >> 
> >> This is going to be reverted for now -- I meant to leave it out of the
> >> last patchset because of the need to update all boards (which the patch
> >> did not do).
> > 
> > Sorry, I didn't get you. Could you please elaborate?
> 
> It was intended to reduce U-Boot code size in cases where soft ECC is
> not needed.  However, the patch that introduced it did not update the
> boards to select it when necessary, so it is being reverted for now.

Okay, but it does not "hurt" to add this define to platforms using soft ECC 
right now, when such NAND driver related config options are updated? Or would 
you advise to remove it for now?

Thanks,
Stefan

--
DENX Software Engineering GmbH,      MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich,  Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-0 Fax: (+49)-8142-66989-80 Email: office at denx.de