[U-Boot] [PATCH v2] add new board nas62x0

[Prafulla Wadaskar]

> -----Original Message-----
> From: Marek Vasut [mailto:marex at denx.de]
> Sent: 21 March 2012 15:33
> To: Prafulla Wadaskar
> Cc: Luka Perkov; u-boot at lists.denx.de; dreagle at doukki.net; Wolfgang
> Denk
> Subject: Re: [U-Boot] [PATCH v2] add new board nas62x0
> 
> Dear Prafulla Wadaskar,
...snip...
> >
> > Hi Luka
> >
> > #1: Defining these values as 0xffffffff, indicates that all GPIOs
> are
> > configured high by default. so this configuration solely depends
> upon your
> > board requirement.
> >
> > #2: on kirkwood, you should define CONFIG_SKIP_LOWLEVEL_INIT since
> > lowlevel_init is not needed on Kirkwood platforms. (ref:
> > doc/README.kwbimage)
> 
> Prafulla, you're then missing the fiddling with CPSR bits, which might
> be quite
> necessary.

Hi Marek.
May be, may you please explain these bits? Or any pointers? Can't these be addressed in kwimage.cfg?

Regards..
Prafulla . . .