[U-Boot] [PATCH] powerpc/85xx: don't touch MAS7 on e500v1 when relocating CCSR

[Timur Tabi]

The CCSR relocation code in start.S writes to MAS7 on all e500 parts, but
that register does not exist on e500v1.

Signed-off-by: Timur Tabi <timur at freescale.com>
---
 arch/powerpc/cpu/mpc85xx/start.S |    8 ++++++--
 1 file changed, 6 insertions(+), 2 deletions(-)

diff --git a/arch/powerpc/cpu/mpc85xx/start.S b/arch/powerpc/cpu/mpc85xx/start.S
index 4d37d6e..d0872cf 100644
--- a/arch/powerpc/cpu/mpc85xx/start.S
+++ b/arch/powerpc/cpu/mpc85xx/start.S
@@ -434,13 +434,15 @@ create_ccsr_new_tlb:
 	ori     r2, r2, FSL_BOOKE_MAS2(CONFIG_SYS_CCSRBAR, (MAS2_I|MAS2_G))@l
 	lis     r3, FSL_BOOKE_MAS3(CONFIG_SYS_CCSRBAR_PHYS_LOW, 0, (MAS3_SW|MAS3_SR))@h
 	ori     r3, r3, FSL_BOOKE_MAS3(CONFIG_SYS_CCSRBAR_PHYS_LOW, 0, (MAS3_SW|MAS3_SR))@l
+#ifdef CONFIG_ENABLE_36BIT_PHYS
 	lis	r7, CONFIG_SYS_CCSRBAR_PHYS_HIGH at h
 	ori	r7, r7, CONFIG_SYS_CCSRBAR_PHYS_HIGH at l
+	mtspr   MAS7, r7
+#endif
 	mtspr   MAS0, r0
 	mtspr   MAS1, r1
 	mtspr   MAS2, r2
 	mtspr   MAS3, r3
-	mtspr   MAS7, r7
 	isync
 	msync
 	tlbwe
@@ -456,12 +458,14 @@ create_ccsr_old_tlb:
 	ori     r2, r2, FSL_BOOKE_MAS2(CONFIG_SYS_CCSRBAR + 0x1000, (MAS2_I|MAS2_G))@l
 	lis     r3, FSL_BOOKE_MAS3(CONFIG_SYS_CCSRBAR_DEFAULT, 0, (MAS3_SW|MAS3_SR))@h
 	ori     r3, r3, FSL_BOOKE_MAS3(CONFIG_SYS_CCSRBAR_DEFAULT, 0, (MAS3_SW|MAS3_SR))@l
+#ifdef CONFIG_ENABLE_36BIT_PHYS
 	li	r7, 0	/* The default CCSR address is always a 32-bit number */
+	mtspr   MAS7, r7
+#endif
 	mtspr   MAS0, r0
 	/* MAS1 is the same as above */
 	mtspr   MAS2, r2
 	mtspr   MAS3, r3
-	mtspr   MAS7, r7
 	isync
 	msync
 	tlbwe
-- 
1.7.10.rc1.8.ga99c5.dirty