[U-Boot] [PATCH] kirkwood: add support for D-Link DNS-320

[Luka Perkov]

Hi Jamie,

I know that you have sent newer version of this patch but here is easier
for me to comment... I have also put maintainer of NAS325 board in
CC.


On Thu, Apr 26, 2012 at 11:23:58AM +0100, Jamie Lentin wrote:
> This patch adds support for D-Link DNS-320 ShareCenter NAS.

...

> +#ifdef CONFIG_RESET_PHY_R
> +/* Configure and initialize PHY */
> +void reset_phy(void)
> +{
> +	u16 reg;
> +	u16 devadr;
> +	char *name = "egiga0";
> +
> +	if (miiphy_set_current_dev(name))
> +		return;
> +
> +	/* command to read PHY dev address */
> +	if (miiphy_read(name, 0xEE, 0xEE, (u16 *) &devadr)) {
> +		printf("Err..(%s) could not read PHY dev address\n", __func__);
> +		return;
> +	}
> +
> +	/*
> +	 * Enable RGMII delay on Tx and Rx for CPU port
> +	 * Ref: sec 4.7.2 of chip datasheet
> +	 */
> +	miiphy_write(name, devadr, MV88E1116_PGADR_REG, 2);
> +	miiphy_read(name, devadr, MV88E1116_MAC_CTRL_REG, &reg);
> +	reg |= (MV88E1116_RGMII_RXTM_CTRL | MV88E1116_RGMII_TXTM_CTRL);
> +	miiphy_write(name, devadr, MV88E1116_MAC_CTRL_REG, reg);
> +	miiphy_write(name, devadr, MV88E1116_PGADR_REG, 0);
> +
> +	/* reset the phy */
> +	miiphy_reset(name, devadr);
> +
> +	debug("88E1116 Initialized on %s\n", name);
> +}
> +#endif /* CONFIG_RESET_PHY_R */

Are you sure you need this CONFIG_RESET_PHY_R at all? I mean I have the
same SoC and I do not need this at all. I think this part is left over
from other boards that we do not need anymore. It makes sense to remove
this if you do not need it on your board.

Take a look here:

http://git.denx.de/?p=u-boot/u-boot-arm.git;a=blob;f=board/raidsonic/ib62x0/ib62x0.c;h=65f2c2ea6a0415b0f508bc078528884e526dd201;hb=HEAD

Luka