[U-Boot] [PATCH 3/4] mx53loco: Turn on VUSB regulator

[Stefano Babic]

On 07/05/2012 22:26, Fabio Estevam wrote:
> From: Fabio Estevam <fabio.estevam at freescale.com>
> 
> On the mx53loco board with mc34708 PMIC it is necessary to turn on VUSB regulator
> so that the mx53 USBH1 PHY receives the 3.3V voltage.
> 
> Tested by inserting a USB pen drive in the upper USB slot (USBH1) and then issued the
> commands:
> 
> usb start
> 
> usb info
> 
> ,which correctly detected and printed the USB pen drive information.
> 
> Signed-off-by: Fabio Estevam <fabio.estevam at freescale.com>
> ---


Acked-by: Stefano Babic <sbabic at denx.de>

Best regards,
Stefano Babic




-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================