[U-Boot] [PATCH] arm,davinci: update for enbw_cmc board

[Tom Rini]

On Sat, May 05, 2012 at 08:32:50AM +0200, Heiko Schocher wrote:

> - change gpio pin settings:
> 
>   - gpio pin 6[13] (PLC reset) default value low
>   - gpio pin 6[0] (TPM reset) default value low
>   - 4 new GPIO pins
>       pin  i/o   name
>     - 3[9] input Board Type
>     - 2[7] input HW-ID0
>     - 2[6] input HW-ID1
>     - 2[3] input HW-ID2
> 
> - read board type and hw id from gpio pins on the enbw_cmc board,
>   and use board type for setting up different gpio pin settings.
> 
> - do not pass "davinci_mmc.use_dma=0" to linux, as MMC now
>   works with DMA.
> 
> - update logbuf support:
>   store post word in RTC scratch register
> 
> - add support for configuring KSZ8864RMN switch through
>   a config file on u-boot startup. For more infos see:
>   doc/README.switch_config
> 
> Signed-off-by: Heiko Schocher <hs at denx.de>
> Cc: Wolfgang Denk <wd at denx.de>
> Cc: Tom Rini <tom.rini at gmail.com>
> Cc: Christian Riesch <christian.riesch at omicron.at>
> Cc: Sandeep Paulraj <s-paulraj at ti.com>

Applied to u-boot-ti/master, thanks.

-- 
Tom