[U-Boot] [PATCH] mx6: clock: Only show CSPI clock if CSPI is enabled

Dirk Behme dirk.behme at gmail.com
Fri Nov 16 17:54:30 CET 2012


Am 16.11.2012 12:30, schrieb Fabio Estevam:
> From: Fabio Estevam <fabio.estevam at freescale.com>
>
> If a board does not enable CSPI, there is no need to show the CSPI clock
> frequency as part of the 'clock' command.
>
> Reported-by: Dirk Behme <dirk.behme at gmail.com>
> Signed-off-by: Fabio Estevam <fabio.estevam at freescale.com>

Acked-by: Dirk Behme <dirk.behme at gmail.com>

Thanks

Dirk

> ---
>   arch/arm/cpu/armv7/mx6/clock.c |    2 ++
>   1 file changed, 2 insertions(+)
>
> diff --git a/arch/arm/cpu/armv7/mx6/clock.c b/arch/arm/cpu/armv7/mx6/clock.c
> index a01d96f..a50db70 100644
> --- a/arch/arm/cpu/armv7/mx6/clock.c
> +++ b/arch/arm/cpu/armv7/mx6/clock.c
> @@ -404,7 +404,9 @@ int do_mx6_showclocks(cmd_tbl_t *cmdtp, int flag, int argc, char * const argv[])
>   	printf("\n");
>   	printf("IPG        %8d kHz\n", mxc_get_clock(MXC_IPG_CLK) / 1000);
>   	printf("UART       %8d kHz\n", mxc_get_clock(MXC_UART_CLK) / 1000);
> +#ifdef CONFIG_MXC_SPI
>   	printf("CSPI       %8d kHz\n", mxc_get_clock(MXC_CSPI_CLK) / 1000);
> +#endif
>   	printf("AHB        %8d kHz\n", mxc_get_clock(MXC_AHB_CLK) / 1000);
>   	printf("AXI        %8d kHz\n", mxc_get_clock(MXC_AXI_CLK) / 1000);
>   	printf("DDR        %8d kHz\n", mxc_get_clock(MXC_DDR_CLK) / 1000);
>



More information about the U-Boot mailing list