[U-Boot] Has anyone gotten the mmc commands to work on the NOVSOMTMi.MX6Q-SL-1-D, on the NOVPEK board by Novtech?

[Greg Topmiller]

Thanks for the response Merek.  I got it working.  I forgot to set the pad setting for the sdhc pins.

Thanks,

Greg

-----Original Message-----
From: Marek Vasut [mailto:marex at denx.de] 
Sent: Tuesday, October 02, 2012 6:18 AM
To: u-boot at lists.denx.de
Cc: Greg Topmiller
Subject: Re: [U-Boot] Has anyone gotten the mmc commands to work on the NOVSOMTMi.MX6Q-SL-1-D, on the NOVPEK board by Novtech?

Dear Greg Topmiller,

> I am using release 2012.07 of u-boot with board type freescale/mx6qarm2. 
> The mx6qarm2 is what is used as the board type in the freescale u-boot 
> delivered with the board.  We want to use the main line u-boot 2012.07.
> To get it working I had to change the serial port and it boots ok.  I 
> also noticed sdhc1 and sdhc2 were not being initialized with 
> fsl_esdhc_initialize.  I tried to initialize them but it hangs on "mmc 
> rescan".  I turned on CONFIG_MMC_TRACE and get the following.
[..]

Do you supply power to the card ?

Best regards,
Marek Vasut