[U-Boot] [PATCH V3 30/32] mx6qsabrelite: change CONFIG_SYS_PROMPT

[stefano babic]

Am 08/10/2012 23:58, schrieb Troy Kisky:
> On 10/8/2012 6:54 AM, Stefano Babic wrote:
>> On 05/10/2012 01:28, Troy Kisky wrote:
>>> On 10/3/2012 8:00 PM, Otavio Salvador wrote:
>>>> On Wed, Oct 3, 2012 at 10:47 PM, Troy Kisky
>>>> <troy.kisky at boundarydevices.com> wrote:
>>>>> The prompt is not appropriate if not running on
>>>>> a mx6q processor.
>>>>>
>>>>> Signed-off-by: Troy Kisky <troy.kisky at boundarydevices.com>
>>>> But in this case the board name will change, no?
>>>>
>>> No, patch 29/32 sets the new boards to use the same config file
>>> (mx6qsabrelite.h) only adding ",MX6DL" or ",MX6S" or ",MX6Q"
>>> to the end of the line in boards.cfg
>> This means that CONFIG_MX6Dx is set. You can use it to set appropriately
>> the prompt or use a more generic name including the board name, as
>> "MX6SABRELITE U-Boot > ". The board is always the same, what is
> 
> I can live with "MX6SABRELITE U-Boot" but I prefer a plain "U-Boot".
> The rest seems a waste of screen real estate. The long u-boot commands
> are more likely to wrap.

Personally agree, shorter is better.

Regards,
Stefano

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================