[U-Boot] [PATCH] OMAP3: igep0020: Add pad config for WIFI/BT GPIOs

Anders Hedlund anders.j.hedlund at gmail.com
Sun Oct 28 02:42:01 CEST 2012


This adds support for WIFI/BT GPIOs which were previously missing.

Signed-off-by: Anders Hedlund <anders.j.hedlund at gmail.com>
Cc: Enric Balletbo i Serra <eballetbo at iseebcn.com>
Cc: Jonas Zetterberg <jozz at jozz.se>
---
 board/isee/igep0020/igep0020.h |    6 ++++++
 1 file changed, 6 insertions(+)

diff --git a/board/isee/igep0020/igep0020.h b/board/isee/igep0020/igep0020.h
index 3335ecc..283b75e 100644
--- a/board/isee/igep0020/igep0020.h
+++ b/board/isee/igep0020/igep0020.h
@@ -132,6 +132,12 @@ static void setup_net_chip(void);
 	MUX_VAL(CP(MMC1_DAT1),      (IEN  | PTU | EN  | M0)) /* MMC1_DAT1 */\
 	MUX_VAL(CP(MMC1_DAT2),      (IEN  | PTU | EN  | M0)) /* MMC1_DAT2 */\
 	MUX_VAL(CP(MMC1_DAT3),      (IEN  | PTU | EN  | M0)) /* MMC1_DAT3 */\
+	MUX_VAL(CP(CAM_HS),         (IDIS | PTU | DIS | M4)) /* GPIO_94 */\
+	MUX_VAL(CP(CAM_VS),         (IDIS | PTU | DIS | M4)) /* GPIO_95 */\
+	MUX_VAL(CP(MMC2_DAT4),      (IDIS | PTU | DIS | M4)) /* GPIO_136 */\
+	MUX_VAL(CP(MMC2_DAT5),      (IDIS | PTU | DIS | M4)) /* GPIO_137 */\
+	MUX_VAL(CP(MMC2_DAT6),      (IDIS | PTU | DIS | M4)) /* GPIO_138 */\
+	MUX_VAL(CP(MMC2_DAT7),      (IDIS | PTU | DIS | M4)) /* GPIO_139 */\
 	MUX_VAL(CP(UART3_TX_IRTX),  (IDIS | PTD | DIS | M0)) /* UART3_TX */\
 	MUX_VAL(CP(UART3_RX_IRRX),  (IEN  | PTD | DIS | M0)) /* UART3_RX */\
 	MUX_VAL(CP(I2C1_SCL),       (IEN  | PTU | EN  | M0)) /* I2C1_SCL */\
-- 
1.7.10.4



More information about the U-Boot mailing list