[U-Boot] [NEXT PATCH v1 2/7] NAND: added NAND type to nand_ids

[Stefano Babic]

On 07/09/2012 11:12, Stefano Babic wrote:
> On 07/09/2012 01:19, Scott Wood wrote:
>> On 09/06/2012 03:04 AM, Stefano Babic wrote:
>>> Signed-off-by: Stefano Babic <sbabic at denx.de>
>>> ---
> 
> Hi Scott,
> 
>>>  drivers/mtd/nand/nand_ids.c |    2 ++
>>>  1 file changed, 2 insertions(+)
>>>
>>> diff --git a/drivers/mtd/nand/nand_ids.c b/drivers/mtd/nand/nand_ids.c
>>> index 3953549..fe75686 100644
>>> --- a/drivers/mtd/nand/nand_ids.c
>>> +++ b/drivers/mtd/nand/nand_ids.c
>>> @@ -131,6 +131,8 @@ const struct nand_flash_dev nand_flash_ids[] = {
>>>  	/* 128 Gigabit */
>>>  	{"NAND 16GiB 1,8V 8-bit",	0x1A, 0, 16384, 0, LP_OPTIONS},
>>>  	{"NAND 16GiB 3,3V 8-bit",	0x3A, 0, 16384, 0, LP_OPTIONS},
>>> +	{"NAND 16GiB 3,3V 8-bit",	0x48, 4096, 16384, 0x100000,
>>> +		LP_OPTIONS},
>>>  	{"NAND 16GiB 1,8V 16-bit",	0x2A, 0, 16384, 0, LP_OPTIONS16},
>>>  	{"NAND 16GiB 3,3V 16-bit",	0x4A, 0, 16384, 0, LP_OPTIONS16},
>>>  
>>>
>>
>> Why does this NAND chip need things specified that are zeroes for other
>> chips?
> 
> At least on this board with MX35, the chip cannot be recognized.
> Manufacturer ID and device ID are read flawlessly, but then u-boot fails
> to get the correct geometry. Setting explicitely the values, I can then
> read / write into the NAND without any problem. It can be more a problem
> related to the specific MXC NAND driver (mxc_nand.c).

It seems to me that the values returned by this flash cannot be
interpreted in nand_get_flash_type().

The values returned from a READ-ID command with address 0x00 are:

	0x2C 0x48 0x04 0x4A 0xA5,

I can really get these values from the flash, so the MXC controller gets
the correct data.

However, the code in nand_base.c (lines from 2718, so not-Samsung case)
parses the answer setting the NAND as a 16-bit device, but this is
really a 8bit device. I do not know the meaning of the answer, it is not
described in the datasheet.

Cheers,
Stefano

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================