[U-Boot] [NEXT PATCH v1 5/7] SPL: Added MLO for mx35 SOC to SPL Makefile

[Stefano Babic]

On 10/09/2012 14:27, Thomas Petazzoni wrote:
> Hello,
> 

Hi Thomas,

>> Exactly. The ROM does not understand a filesystem, and the SPL must be
>> stored at a fixed address in the SD card. The filename does not matter,
>> and the SPL is not seen as file, but as a raw image.
>>
>>>  I'm fine
>>> with the change now, just looking for the full details.  Thanks!
>>
>> As for Freescale the filename does not matter while for TI does, we can
>> use for both MLO ;-)
> 
> Then in that case I would precisely *not* use the same filename, in
> order to make it clear that Freescale SPL cannot be used in the same
> way as the TI SPL. Naming it MLO will certainly confuse users having
> previous experience with TI stuff: it will lead them to believe that
> creating a FAT filesystem and putting the MLO file in it will be the
> necessary steps to get this SPL loaded by the ROM code.

Of couse, setting a common name is not a reason enough for the users to
not read the manual ;-). The way TI and Freescale have chosen to boot
their SOCs are and remain quite differently.

The reason to have a common name is to avoid to document for each SOC
which is the binary result. Maybe a more neutral name as "SPL" instead
of "MLO" ? This is the first attempt to set SPL for a not-TI SOC, but
hopefully other SOCs will follow, and it is better to set already some
simple rules,

In any case, the resulting binary is a different thing as how to put the
binary into the target: SPL can be copied as MLO on the SD-Card. Tom,
what do you think ?

Best regards,
Stefano

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================