[U-Boot] Help Required [imx35pdk]
stefano babic
sbabic at denx.de
Thu Sep 13 09:48:33 CEST 2012
Am 13/09/2012 06:55, schrieb Fabio Estevam:
> Hi Stefano,
>
> On Wed, Sep 12, 2012 at 6:44 PM, stefano babic <sbabic at denx.de> wrote:
>
>> U-Boot for mx35pdk runs from NOR and not from NAND. There is no support
>> to run from NAND. Even if I can "convince" the board to boot from NAND,
>> this was not pushed to mainline. I explain why.
>
> Reading board/freescale/mx35pdk/README it gives the impression that
> booting from NAND is supported.
It is a wrong impression, it is not (yet) supported..
>
> Should this be updated?
Yes !
Regards,
Stefano
--
=====================================================================
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: office at denx.de
=====================================================================
More information about the U-Boot
mailing list