[U-Boot] [PATCH v2] ARM: Add X600 board support (SPEAr600 based)

[Stefan Roese]

Hi Tom,

On 09/03/2012 07:58 AM, Stefan Roese wrote:
> Hi Wolfgang,
> 
> On 09/02/2012 04:53 PM, Wolfgang Denk wrote:
>> In message <1338454748-16315-1-git-send-email-sr at denx.de> you wrote:
>>> This patch adds support for the X600 SPEAr600 based board. Its also
>>> the first SPEAr600 board that uses the newly introduced SPEAr600
>>> SPL support. Xloader is not necessary any more. By using the new
>>> "u-boot.spr" make target, one image will generated containing both,
>>> U-Boot SPL (with mkimage header as needed by the SPEAr BootROM, and
>>> the main U-Boot with mkimage header.
>>>
>>> Signed-off-by: Stefan Roese <sr at denx.de>
>>> Cc: Amit Virdi <amit.virdi at st.com>
>>> Cc: Vipin Kumar <vipin.kumar at st.com>
>>> ---
>>> v2:
>>> - Add hush support
>>> - Add bootcount & altbootcmd support
>>
>> What exactly is the state of these patches?  When are these supposed
>> to me pulled into mainline?
> 
> The state is "good for pulling". Now that the bootcount consolidation
> support is mainlined, this x600 support should really go in.
> 
> Albert, will you pull this patch?

This patch is also waiting for upstreaming quite some time. No comment
till now.

Tom, can you pull it directly? Shall I assign it to you in patchworks?

Thanks,
Stefan