[U-Boot] [PATCH 1/4 v2] serial: Add Zynq serial driver

[Marek Vasut]

Dear Michal Simek,

> On 09/13/2012 02:33 PM, Marek Vasut wrote:
> > Dear Michal Simek,
> > 
> >> On 09/13/2012 11:21 AM, Marek Vasut wrote:
> >>> Dear Michal Simek,
> >>> 
> >>>> The driver is used on Xilinx Zynq platform.
> >>>> 
> >>>> Signed-off-by: Michal Simek <monstr at monstr.eu>
> >>>> 
> >>>> ---
> >>>> v2: Use Zynq name instead of Dragonfire and XPSS/XDFUART
> >>>> 
> >>>>       Rename driver name
> >>>>       Remove driver description
> >>>> 
> >>>> ---
> >>>> 
> >>>>    drivers/serial/Makefile      |    1 +
> >>>>    drivers/serial/serial_zynq.c |  200
> >>>> 
> >>>> ++++++++++++++++++++++++++++++++++++++++++ 2 files changed, 201
> >>>> insertions(+), 0 deletions(-)
> >>>> 
> >>>>    create mode 100644 drivers/serial/serial_zynq.c
> >>> 
> >>> [...]
> >>> 
> >>> It looks ok, but can you make it support CONFIG_SERIAL_MULTI right away
> >>> please?
> >> 
> >> Yes, it will add serial_multi in the next patch.
> >> Can you give me your ACK or reviewed-by line? :-)
> > 
> > Just squash them into one patch please.
> 
> Done.

Thanks ... my idea is to switch to serial_multi completely, then rework stdio, 
unify serial on top of it and clean up the whole subsystem. Thanks for helping!

> Michal

Best regards,
Marek Vasut