[U-Boot] R: Configure a Numonyx Axcell M29EW on a MPC8323 board

[SETTE AGOSTINO - technolabs]

Hi Stefano,

yes, the macro MEG_TO_AM () should work on my SOC (I see it is used on MPC8323RDB, my hw is quite similar to this one).

Thanks for your support

Best regards,
Agostino


-----Messaggio originale-----
Da: Stefano Babic [mailto:sbabic at denx.de] 
Inviato: mercoledì 26 settembre 2012 16.41
A: SETTE AGOSTINO - technolabs
Cc: u-boot at lists.denx.de
Oggetto: Re: [U-Boot] Configure a Numonyx Axcell M29EW on a MPC8323 board

On 25/09/2012 08:59, SETTE AGOSTINO - technolabs wrote:
> Hi all,
> 
> 
> (2 << BR_PS_SHIFT) | /* 16 bit port size */ \
> 
> BR_V) /* valid */
> 
> @
> 
> #define CONFIG_SYS_OR0_PRELIM 0x00007ff7 /* 512MB Flash size */

Without checking the manual, this seems wrong. It seems to me that the timing is set, but not the size. Does the macro MEG_TO_AM() work on your SOC ?

Best regards,
Stefano

--
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de =====================================================================