[U-Boot] [PATCH] mtd: nand: omap: fix ecc-layout for HAM1 ecc-scheme

[Pekon Gupta]

As per OMAP3530 TRM referenced below [1]

For large-page NAND, ROM code expects following ecc-layout for HAM1 ecc-scheme
 - OOB[1] (offset of 1 *byte* from start of OOB) for x8 NAND device
 - OOB[2] (offset of 1 *word* from start of OOB) for x16 NAND device

Thus ecc-layout expected by ROM code for HAM1 ecc-scheme is:
 *for x8 NAND Device*
 +--------+---------+---------+---------+---------+---------+---------+
 | xxxx   | ECC[A0] | ECC[A1] | ECC[A2] | ECC[B0] | ECC[B1] | ECC[B2] | ...
 +--------+---------+---------+---------+---------+---------+---------+

 *for x16 NAND Device*
 +--------+--------+---------+---------+---------+---------+---------+---------+
 | xxxxx  | xxxxx  | ECC[A0] | ECC[A1] | ECC[A2] | ECC[B0] | ECC[B1] | ECC[B2] |
 +--------+--------+---------+---------+---------+---------+---------+---------+

This patch fixes ecc-layout *only* for HAM1, as required by ROM-code
For other ecc-schemes like (BCH8) ecc-layout is same for x8 or x16 devices.

[1] OMAP3530: http://www.ti.com/product/omap3530
    TRM: http://www.ti.com/litv/pdf/spruf98x
		Chapter-25: Initialization Sub-topic: Memory Booting
		Section: 25.4.7.4 NAND
		Figure 25-19. ECC Locations in NAND Spare Areas

Reported-by: Stefan Roese <sr at denx.de>
Signed-off-by: Pekon Gupta <pekon at ti.com>
---
 drivers/mtd/nand/omap_gpmc.c | 8 ++++++--
 1 file changed, 6 insertions(+), 2 deletions(-)

diff --git a/drivers/mtd/nand/omap_gpmc.c b/drivers/mtd/nand/omap_gpmc.c
index 887b38b..fae00be 100644
--- a/drivers/mtd/nand/omap_gpmc.c
+++ b/drivers/mtd/nand/omap_gpmc.c
@@ -626,8 +626,12 @@ static int omap_select_ecc_scheme(struct nand_chip *nand,
 		nand->ecc.calculate	= omap_calculate_ecc;
 		/* define ecc-layout */
 		ecclayout->eccbytes	= nand->ecc.bytes * eccsteps;
-		for (i = 0; i < ecclayout->eccbytes; i++)
-			ecclayout->eccpos[i] = i + BADBLOCK_MARKER_LENGTH;
+		for (i = 0; i < ecclayout->eccbytes; i++) {
+			if (nand->options & NAND_BUSWIDTH_16)
+				ecclayout->eccpos[i] = i + 2;
+			else
+				ecclayout->eccpos[i] = i + 1;
+		}
 		ecclayout->oobfree[0].offset = i + BADBLOCK_MARKER_LENGTH;
 		ecclayout->oobfree[0].length = oobsize - ecclayout->eccbytes -
 						BADBLOCK_MARKER_LENGTH;
-- 
1.8.1