[U-Boot] [U-Boot,v3,2/2] arm, at91: add siemens corvus board

[Andreas Bießmann]

Dear Heiko Schocher,

Heiko Schocher <hs at denx.de> writes:
>enable support for the siemens AT91SAM9G20 based board corvus.
>
>Signed-off-by: Boris Schmidt <boris.schmidt at siemens.com>
>Reviewed-by: Heiko Schocher <hs at denx.de>
>Cc: Andreas Bießmann <andreas.devel at googlemail.com>
>Cc: Bo Shen <voice.shen at atmel.com>
>
>---
>- changes for v2:
>  - add comments from Bo Shen
>      - use gpio api
>      - remove unneccessary comment
>      - use at91_wait_for_reset()
>      - remove unneccessary code in board file
>      - Coding Style cleanup (tabs and unneccessary 1 after config define
>        removed, use ".xxx = x" notation for initializing structs)
>      - remove reset_phy()
>      - remove CONFIG_SYS_MEMTEST_x defines, as mtest command
>        is not used on this board.
>      - changes load address
>      - delete lcd support
>  - add comments from Andreas Bießmann:
>    - rearrange some init calls
>    - remove some unneeded ifdef
>- changes for v3:
>  - add comments from Andreas Bießmann:
>    - removed at91sam9m10g45ek_usb_hw_init() call
>    - removed empty reset_phy
>    - removed unneccessary tab
>  - use at91_phy_reset()
>  - rebased against current commit
>    2cee0408e5c6f5dbdfa89fb40168ba2ead3f61a6
>  - add CONFIG_AT91_WANTS_COMMON_PHY
>---
> board/siemens/corvus/Makefile |  18 ++++
> board/siemens/corvus/board.c  | 195 ++++++++++++++++++++++++++++++++++++++++++
> boards.cfg                    |   1 +
> include/configs/corvus.h      | 165 +++++++++++++++++++++++++++++++++++
> 4 files changed, 379 insertions(+)
> create mode 100644 board/siemens/corvus/Makefile
> create mode 100644 board/siemens/corvus/board.c
> create mode 100644 include/configs/corvus.h

applied to u-boot-atmel/master, thanks!

Best regards,
Andreas Bießmann