[U-Boot] [PATCH 1/2] doc: README.fuse: Add an example on how to use the fuse API on mx6q

[Fabio Estevam]

From: Fabio Estevam <fabio.estevam at freescale.com>

When using the fuse API in U-boot user must calculate the 'bank' and 'word' 
values. 

Provide a real example on how to calculate such values for the mx6q.

Signed-off-by: Fabio Estevam <fabio.estevam at freescale.com>
---
 doc/README.fuse | 57 +++++++++++++++++++++++++++++++++++++++++++++++++++++++++
 1 file changed, 57 insertions(+)

diff --git a/doc/README.fuse b/doc/README.fuse
index 1bc91c4..aca1e5e 100644
--- a/doc/README.fuse
+++ b/doc/README.fuse
@@ -65,3 +65,60 @@ Configuration:
 
    CONFIG_CMD_FUSE
       Define this to enable the fuse commands.
+
+Example:
+
+For reading the MAC address fuses on a MX6Q:
+
+- The MAC address are stored in two fuse addresses (the fuse addresses are
+described in the Fusemap Descriptions table from the mx6q Reference Manual):
+
+0x620[31:0] - MAC_ADDR[31:0]
+0x630[15:0] - MAC_ADDR[47:32]
+
+In order to use the fuse API, we need to pass the bank and word values, which
+are calculated as below:
+
+Fuse address for the lower MAC address: 0x620
+Base address for the fuses: 0x400
+
+(0x620 - 0x400)/0x10 = 0x22 = 34 decimal
+
+As the fuses are arranged in banks of 8 words:
+
+34 / 8 = 4 and the remainder is 2, so in this case:
+
+bank = 4
+word = 2
+
+And the U-boot command would be:
+
+=> fuse read 4 2
+Reading bank 4:
+
+Word 0x00000002: 9f027772
+
+Doing the same for the upper MAC address:
+
+Fuse address for the upper MAC address: 0x630
+Base address for the fuses: 0x400
+
+(0x630 - 0x400)/0x10 = 0x23 = 35 decimal
+
+As the fuses are arranged in banks of 8 words:
+
+35 / 8 = 4 and the remainder is 3, so in this case:
+
+bank = 4
+word = 3
+
+And the U-boot command would be:
+
+=> fuse read 4 3
+Reading bank 4:
+
+Word 0x00000003: 00000004
+
+,which matches the ethaddr value:
+=> echo ${ethaddr}
+00:04:9f:02:77:72
-- 
1.8.1.2