[U-Boot] [PATCH v7 15/19] nand: mxc: Switch NAND SPL to generic SPL

Benoît Thébaudeau benoit.thebaudeau at advansee.com
Fri Feb 22 23:42:56 CET 2013


Hi Fabio,

On Friday, February 22, 2013 11:08:14 PM, Fabio Estevam wrote:
> On Fri, Feb 22, 2013 at 7:03 PM, Fabio Estevam <festevam at gmail.com> wrote:
> > On Fri, Feb 22, 2013 at 7:02 PM, Fabio Estevam <festevam at gmail.com> wrote:
> >
> >> U-Boot code: 87F00000 -> 87F2C184  BSS: -> 87F311B4
> >> CPU:   Freescale i.MX31 rev 2.0 at 532 MHz.
> >> Reset cause: WDOG
> >> Board: MX31PDK
> >> monitor len: 000311B4
> >> ramsize: 08000000
> >> TLB table from 87ff0000 to 87ff4000
> >> Top of RAM usable for U-Boot at: 87ff0000
> >> Reserving 196k for U-Boot at: 87fbe000
> >> Reserving 640k for malloc() at: 87f1e000
> >> Reserving 32 Bytes for Board Info at: 87f1dfe0
> >> Reserving 128 Bytes for Global Data at: 87f1df60
> >> New Stack Pointer is: 87f1df50
> >> RAM Configuration:
> >> Bank #0: 80000000 128 MiB
> >> relocation Offset is: 000be000
> >> monitor flash len: 00030F7C
> >> Now running in RAM - U-Boot at: 87fbe000
> >> NAND:  256 MiB
> >
> > and after this it does not hang, it keeps resetting forever.
> 
> I disabled watchdog and now I can reach U-boot prompt :-)  Thanks
> Benoit and Troy!
> 
> Will fix the watchdog later.

Great! So can you confirm that for my series, all I have to change is:
#define CONFIG_SYS_NAND_U_BOOT_SIZE   0x32000
?

Did you also have a chance to test nand commands on mx53ard?

Thanks for all your tests.

Best regards,
Benoît


More information about the U-Boot mailing list