[U-Boot] [PATCH v3 3/3] arm: omap3: Add SPL support to cm_t35

[Stefan Roese]

Hi Albert,

On 07/30/2013 02:10 PM, Albert ARIBAUD wrote:
>> Add SPL U-Boot support to replace x-loader on the Compulab cm_t35
>> board. Currently only the 256MiB SDRAM board versions are supported.
>>
>> Tested by booting via MMC and NAND.
>>
>> Signed-off-by: Stefan Roese <sr at denx.de>
>> Cc: Tom Rini <trini at ti.com>
>> Cc: Igor Grinberg <grinberg at compulab.co.il>
>> ---
>> v3:
>> - Some instability of this SDRAM setup has been detected while running
>>   Linux. Comparison with the x-loader setup showed that mcfg is configured
>>   slightly differently here. CM_T35 needs RAS-width of 14 instead of
>>   13. So use the define MICRON_V_MCFG_200 which implements this 14
>>   as RAS width.
>>
>> v2:
> 
> I assume this means that your request to Tom about PRing V2 is withdrawn
> and I can apply his PR as-is. Correct?

Yes. Please go ahead and pull. We can apply this patch at a later time.

Thanks,
Stefan