[U-Boot] [PATCH V5] ARM: OMAP: I2C: New read, write and probe functions

[Heiko Schocher]

Hello Lubomir,

Am 03.06.2013 07:13, schrieb Heiko Schocher:
> Hello Lubomir,
> 
> Am 02.06.2013 13:42, schrieb Lubomir Popov:
>>> Hello Lubomir,
>>>
>>> Am 01.06.2013 18:44, schrieb Lubomir Popov:
>>>> New i2c_read, i2c_write and i2c_probe functions, tested on OMAP4
>>>> (4430/60/70), OMAP5 (5430) and AM335X (3359); should work on older
>>>> OMAPs and derivatives as well. The only anticipated exception would
>>>> be the OMAP2420, which shall require driver modification.
> [...]
>>>>  drivers/i2c/omap24xx_i2c.c | 490 +++++++++++++++++++++++++++------------------
>>>>  1 file changed, 299 insertions(+), 191 deletions(-)
>>>
>>> Tested on 3 arm335x based boards, which one uses i2c in SPL
>>> code for getting ram parameters, so:
>>>
>>> Tested-by: Heiko Schocher <hs at denx.de>
>> Many thanks for testing, to Tom as well (he did it on the
>> Beagleboards, but for one of the older versions, V3 I believe,
>> right?).
>> When it comes to versions, I see that V1 and V2 are still listed
>> in patchwork, probably because of slightly different wording of
>> the subject:
>> http://patchwork.ozlabs.org/patch/233823/
>> http://patchwork.ozlabs.org/patch/246204/
>> Could you or Tom clean this up, please? Thanks.
> 
> Cleared the v3 v4 version, but missed the v2 and v1, Done.

just doing a "MAKEALL arm" with your patch applied and get this error:

Configuring for omap2420h4 board...
omap24xx_i2c.c:497:17: error: 'struct i2c' has no member named 'irqstatus_raw'
omap24xx_i2c.c:528:12: error: 'struct i2c' has no member named 'irqstatus_raw'
arm-linux-gnueabi-size: './u-boot': No such file
omap24xx_i2c.c: In function 'wait_for_bb':
omap24xx_i2c.c:497:17: error: 'struct i2c' has no member named 'irqstatus_raw'
omap24xx_i2c.c: In function 'wait_for_event':
omap24xx_i2c.c:528:12: error: 'struct i2c' has no member named 'irqstatus_raw'
make[1]: *** [omap24xx_i2c.o] Fehler 1
make: *** [drivers/i2c/libi2c.o] Fehler 2
make: *** Warte auf noch nicht beendete Prozesse...

Please fix this and run a "MAKEALL arm" before repost, thanks!

bye,
Heiko
-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany