[U-Boot] [PATCH v4 01/14] sf: Add bank address register writing support

[Jagannadha Sutradharudu Teki]

This patch provides support to program a flash bank address
register.

extended/bank address register contains an information to access
the 4th byte addressing in 3-byte address mode.

reff' the spec for more details about bank addr register
in Page-63, Table 8.16
http://www.spansion.com/Support/Datasheets/S25FL128S_256S_00.pdf

Signed-off-by: Jagannadha Sutradharudu Teki <jaganna at xilinx.com>
Reviewed-by: Simon Glass <sjg at chromium.org>
---
Changes for v4:
	- remove bank cmds
Changes for v3:
	- none
Changes for v2:
	- none

 drivers/mtd/spi/spi_flash.c          | 26 ++++++++++++++++++++++++++
 drivers/mtd/spi/spi_flash_internal.h |  3 +++
 2 files changed, 29 insertions(+)

diff --git a/drivers/mtd/spi/spi_flash.c b/drivers/mtd/spi/spi_flash.c
index 0e38f59..9ddd070 100644
--- a/drivers/mtd/spi/spi_flash.c
+++ b/drivers/mtd/spi/spi_flash.c
@@ -278,6 +278,32 @@ int spi_flash_cmd_write_status(struct spi_flash *flash, u8 sr)
 	return 0;
 }
 
+int spi_flash_cmd_bankaddr_write(struct spi_flash *flash, u8 bank_sel)
+{
+	u8 cmd;
+	int ret;
+
+	ret = spi_flash_cmd_write_enable(flash);
+	if (ret < 0) {
+		debug("SF: enabling write failed\n");
+		return ret;
+	}
+
+	ret = spi_flash_cmd_write(flash->spi, &cmd, 1, &bank_sel, 1);
+	if (ret) {
+		debug("SF: fail to write bank addr register\n");
+		return ret;
+	}
+
+	ret = spi_flash_cmd_wait_ready(flash, SPI_FLASH_PROG_TIMEOUT);
+	if (ret < 0) {
+		debug("SF: write bank addr register timed out\n");
+		return ret;
+	}
+
+	return 0;
+}
+
 #ifdef CONFIG_OF_CONTROL
 int spi_flash_decode_fdt(const void *blob, struct spi_flash *flash)
 {
diff --git a/drivers/mtd/spi/spi_flash_internal.h b/drivers/mtd/spi/spi_flash_internal.h
index 141cfa8..772fef6 100644
--- a/drivers/mtd/spi/spi_flash_internal.h
+++ b/drivers/mtd/spi/spi_flash_internal.h
@@ -77,6 +77,9 @@ static inline int spi_flash_cmd_write_disable(struct spi_flash *flash)
 /* Program the status register. */
 int spi_flash_cmd_write_status(struct spi_flash *flash, u8 sr);
 
+/* Program the bank address register */
+int spi_flash_cmd_bankaddr_write(struct spi_flash *flash, u8 bank_sel);
+
 /*
  * Same as spi_flash_cmd_read() except it also claims/releases the SPI
  * bus. Used as common part of the ->read() operation.
-- 
1.8.3