[U-Boot] board/bsc9131rdb: Add targets for Sysclk 100MHz

[Andy Fleming]

On Mon, Apr 01, 2013 at 12:12:45PM +0530, Priyanka Jain wrote:
> BSC9131RDB supports Sysclk
> -66MHz if jumper J16 is close (default state)
> -100MHz if jumper J16 is open
> 
> Add targets
> -BSC9131RDB_NAND_SYSCLK100 : for NAND boot at Sysclk 100MHz
> -BSC9131RDB_SPIFLASH_SYSCLK100: for SPI boot at Sysclk 100MHz
> 
> Signed-off-by: Ramneek Mehresh <ramneek.mehresh at freescale.com>
> Signed-off-by: Priyanka Jain <Priyanka.Jain at freescale.com>
> 
> ---

Applied, thanks!

Andy