[U-Boot] [U-Boot, 2/6, v2] powerpc/boot: Change the macro of Boot from SRIO and PCIE master module

Andy Fleming afleming at freescale.com
Fri Jun 21 22:44:42 CEST 2013


On Tue, May 07, 2013 at 04:30:46PM +0800, Liu Gang wrote:
> Currently, the macro "CONFIG_SYS_FSL_SRIO_PCIE_BOOT_MASTER" can enable
> the master module of Boot from SRIO and PCIE on a platform. But this
> is not a silicon feature, it's just a specific booting mode based on
> the SRIO and PCIE interfaces. So it's inappropriate to put the macro
> into the file arch/powerpc/include/asm/config_mpc85xx.h.
> 
> Change the macro "CONFIG_SYS_FSL_SRIO_PCIE_BOOT_MASTER" to
> "CONFIG_SRIO_PCIE_BOOT_MASTER", remove them from
> arch/powerpc/include/asm/config_mpc85xx.h file, and add those macros
> in configuration header file of each board which can support the
> master module of Boot from SRIO and PCIE.
> 
> Signed-off-by: Liu Gang <Gang.Liu at freescale.com>

Applied, thanks!

Andy



More information about the U-Boot mailing list