[U-Boot] [PATCH v5 12/14] arm: add Faraday specific boot command

[Albert ARIBAUD]

Hi Kuo-Jung,

On Mon, 17 Jun 2013 20:07:02 +0800, Kuo-Jung Su <dantesu at gmail.com>
wrote:

> From: Kuo-Jung Su <dantesu at faraday-tech.com>
> 
> At the time of writting, none of Faraday NAND & SPI controllers
> supports XIP (eXecute In Place). So the Faraday A360/A369 SoC has
> to implement a 1st level bootstrap code stored in the embedded ROM
> inside the SoC.
> 
> After power-on, the ROM code (1st level bootstrap code) would load
> the 2nd bootstrap code into SRAM without any SDRAM initialization.
> 
> The 2nd bootstrap code would then initialize SDRAM and load the
> generic firmware (u-boot/linux) into SDRAM, and finally make
> a long-jump to the firmware.
> 
> Which means the SPL design of U-boot would never fit to A360/A369,
> since it's usually not possible to alter a embedded ROM code.
> And because both the 1st & 2nd level bootstrap code use the private
> Faraday Firmware Image Format, it would be better to drop U-boot
> image support to simplify the design.

Please reword the last sentence: you're not suggesting "to drop 
U-boot support" from U-Boot, right? You're only suggesting adding the
Faraday image format.

Also, maybe the long explanation should go in the cover letter and a
single shorter paragraph should be given as commit message here.

> Signed-off-by: Kuo-Jung Su <dantesu at faraday-tech.com>
> CC: Albert Aribaud <albert.u.boot at aribaud.net>
> ---

Amicalement,
-- 
Albert.