[U-Boot] driver for davicom dm9601 usb-ethernet NIC

[Beagle board]

Hello Everyone,

I'm working on Beagleboard C3, and i'm trying to do an nfs-boot.
Please find below my bootup log. I'm getting the  below error.

After digging into the details of the error, could make out that my
Ethernet NIC is not there in the supported drivers list of U-Boot
{drivers/usb/eth/}

I'm using "Davicom DM9601 USB-Ethernet NIC". I would like to check with u
guys whether u've got any drivers for the same?


???40V???�H��?ս��сSPL 2011.12-00010-ga3eb89c (Jan 29 2012 - 14:53:43)
Texas Instruments Revision detection unimplemented
OMAP SD/MMC: 0
reading u-boot.img
reading u-boot.img


U-Boot 2013.01 (Feb 22 2013 - 13:00:08)

OMAP3530-GP ES3.0, CPU-OPP2, L3-165MHz, Max CPU Clock 600 mHz
OMAP3 Beagle board + LPDDR/NAND
I2C:   ready
DRAM:  256 MiB
NAND:  256 MiB
MMC:   OMAP SD/MMC: 0
*** Warning - bad CRC, using default environment

In:    serial
Out:   serial
Err:   serial
Beagle Rev C1/C2/C3
timed out in wait_for_pin: I2C_STAT=0
No EEPROM on expansion board
timed out in wait_for_pin: I2C_STAT=0
No EEPROM on expansion board
Die ID #12ac000300000000040323090f024015
musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, bulk combine, bulk split,
HB-ISO Rx, HB-ISO Tx, SoftConn)
musb-hdrc: MHDRC RTL version 1.400
musb-hdrc: setup fifo_mode 4
musb-hdrc: 28/31 max ep, 16384/16384 memory
USB Peripheral mode controller at 480ab000 using PIO, IRQ 0
Net:   usb_ether
Hit any key to stop autoboot:  0
mmc0 is current device
gpio: pin 173 (gpio 173) value is 1
gpio: pin 7 (gpio 7) value is 0
SD/MMC found on device 0
reading uEnv.txt
769 bytes read in 3 ms (250 KiB/s)
Loaded environment from uEnv.txt
Importing environment from mmc ...
Running uenvcmd ...
Initializing net ...
(Re)start USB...
USB0:   USB EHCI 1.00
scanning bus 0 for devices... 4 USB Device(s) found
       scanning usb for storage devices... 0 Storage Device(s) found
       scanning usb for ethernet devices... 0 Ethernet Device(s) found
Loading kernel ...
using musb-hdrc, OUT ep1out IN ep1in
MAC 00:60:6e:00:f1:cd
*ERROR: The remote end did not respond in time.
at ether.c:2395/usb_eth_init()*

Booting from nfs ...
Wrong Image Format for bootm command
ERROR: can't get kernel image!