[U-Boot] [PATCH RFC] imx: add multi-architecture README

[Eric Nelson]

Thanks Wolfgang.

On 11/09/2013 02:14 PM, Wolfgang Denk wrote:
> Dear Eric Nelson,
>
> In message <1384027962-11556-1-git-send-email-eric.nelson at boundarydevices.com> you wrote:
> ...
>> +Supporting multiple architectures on Freescale i.MX6
>> +
>> +This file describes how to support multiple CPU architectures
>> +(i.MX6DQ and i.MX6DLS) in a single U-Boot image.
>
> I think the term "architectures" is greatly misleading here. An
> "architecture" is for example ARm or MIPS or Power Architecture.
>
> What you are talking about are mere CPU models.
>
> Please adapt the Subject and commit message.
>

Done. I started typing in "multi-CPU", but that's also overloaded,
so I stumbled on BOMs, since that seems more to the point (that
a board can be assembled using different specific parts).

It still suffers from some awkwardness surrounding what to call
the division between the high-end parts and the low-end.

Choosing words is hard, and suggestions are welcome.

I starting to use the term "SKU", but I'm not sure how commonly
used that term has become.

Regards,


Eric