[U-Boot] [PATCH v1 2/4] udoo: Add ethernet support (FEC + Micrel KSZ9031).

[Fabio Estevam]

On Tue, Nov 12, 2013 at 12:51 PM, Fabio Estevam <festevam at gmail.com> wrote:
> Hi Giuseppe,
>
> On Mon, Nov 11, 2013 at 3:11 PM, Giuseppe Pagano
> <giuseppe.pagano at seco.com> wrote:
>
>> +static iomux_v3_cfg_t const enet_pads1[] = {
>> +       MX6_PAD_ENET_MDIO__ENET_MDIO            | MUX_PAD_CTRL(ENET_PAD_CTRL),
>> +       MX6_PAD_ENET_MDC__ENET_MDC              | MUX_PAD_CTRL(ENET_PAD_CTRL),
>> +       MX6_PAD_RGMII_TXC__ENET_RGMII_TXC       | MUX_PAD_CTRL(ENET_PAD_CTRL),
>> +       MX6_PAD_RGMII_TD0__ENET_RGMII_TD0       | MUX_PAD_CTRL(ENET_PAD_CTRL),
>> +       MX6_PAD_RGMII_TD1__ENET_RGMII_TD1       | MUX_PAD_CTRL(ENET_PAD_CTRL),
>> +       MX6_PAD_RGMII_TD2__ENET_RGMII_TD2       | MUX_PAD_CTRL(ENET_PAD_CTRL),
>> +       MX6_PAD_RGMII_TD3__ENET_RGMII_TD3       | MUX_PAD_CTRL(ENET_PAD_CTRL),
>> +       MX6_PAD_RGMII_TX_CTL__RGMII_TX_CTL      | MUX_PAD_CTRL(ENET_PAD_CTRL),
>> +       MX6_PAD_ENET_REF_CLK__ENET_TX_CLK       | MUX_PAD_CTRL(ENET_PAD_CTRL),
>> +       MX6_PAD_RGMII_RXC__ENET_RGMII_RXC       | MUX_PAD_CTRL(ENET_PAD_CTRL),
>> +       /* RGMII reset */
>> +       MX6_PAD_EIM_D23__GPIO_3_23              | MUX_PAD_CTRL(NO_PAD_CTRL),
>> +       /* alimentazione ethernet*/
>
> Actually this is pin is Ethernet PHY reset, so the comment in Italian
> is not correct :-)

Sorry, I looked at the wrong line. Anyway, please change the comment
to "Ethernet power supply".

Thanks,

Fabio Estevam