[U-Boot] [PATCH v1 1/4] udoo: Move and optimize platform register setting.

[Stefano Babic]

Hi Giuseppe,

On 11/11/2013 18:11, Giuseppe Pagano wrote:
> Previous uDoo configuration adopts register settings for DDR3, clock, muxing, etc. taken from Nitrogen6x.  uDoo schematics is rather different from that board, and it needs customized setting for most of the registers.
> All this changes can be considered atomical since it is part of initial support of the board.
> 
> Patch changes uDoo configuration files path to a specific one, and adopt optimized value for every configured register.
> 
> Signed-off-by: Giuseppe Pagano <giuseppe.pagano at seco.com>
> CC: Stefano Babic <sbabic at denx.de>
> CC: Fabio Estevam <fabio.estevam at freescale.com>
> ---

> diff --git a/boards.cfg b/boards.cfg
> index cec154b..1863f2a 100644
> --- a/boards.cfg
> +++ b/boards.cfg
> @@ -288,7 +288,7 @@ Active  arm         armv7          mx5         freescale       mx53smd
>  Active  arm         armv7          mx5         genesi          mx51_efikamx        mx51_efikamx                         mx51_efikamx:MACH_TYPE=MACH_TYPE_MX51_EFIKAMX,IMX_CONFIG=board/genesi/mx51_efikamx/imximage_mx.cfg                                -
>  Active  arm         armv7          mx5         genesi          mx51_efikamx        mx51_efikasb                         mx51_efikamx:MACH_TYPE=MACH_TYPE_MX51_EFIKASB,IMX_CONFIG=board/genesi/mx51_efikamx/imximage_sb.cfg                                -
>  Active  arm         armv7          mx5         ttcontrol       vision2             vision2                              vision2:IMX_CONFIG=board/ttcontrol/vision2/imximage_hynix.cfg                                                                     Stefano Babic <sbabic at denx.de>
> -Active  arm         armv7          mx6         -               udoo		   udoo_quad				udoo:IMX_CONFIG=board/boundary/nitrogen6x/nitrogen6q.cfg,MX6Q,DDR_MB=1024          Fabio Estevam <fabio.estevam at freescale.com>
> +Active  arm         armv7          mx6         -               udoo		   udoo_quad                            udoo:IMX_CONFIG=board/udoo/udoo.cfg,MX6Q,DDR_MB=1024       Fabio Estevam <fabio.este... at freescale.com>

Fabio's mail address is corrupted by some tool.

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================