[U-Boot] [PATCH 1/2][v2] powerpc: mmc: Add corenet devices support in esdhc spl

Priyanka Jain Priyanka.Jain at freescale.com
Tue Nov 26 07:06:20 CET 2013


Existing eSDHC SPL framework assumes booting from sd-image
with boot_format header which contains final u-boot Image
offset and size. No such header is present in case of
corenet devices like T1040 as corenet deivces use PBI-RCW
based intialization.

So, for corenet deives, SPL bootloader use values provided
at compilation time. These values can be defined in board
specific config file.

Signed-off-by: Priyanka Jain <Priyanka.Jain at freescale.com>
---
Changes for v2:
	Updated description based on Sun York's inputs

 drivers/mmc/fsl_esdhc_spl.c |    5 +++++
 1 files changed, 5 insertions(+), 0 deletions(-)

diff --git a/drivers/mmc/fsl_esdhc_spl.c b/drivers/mmc/fsl_esdhc_spl.c
index 65c52a2..8fc263f 100644
--- a/drivers/mmc/fsl_esdhc_spl.c
+++ b/drivers/mmc/fsl_esdhc_spl.c
@@ -42,6 +42,10 @@ void __noreturn mmc_boot(void)
 		hang();
 	}
 
+#ifdef CONFIG_FSL_CORENET
+	offset = CONFIG_SYS_MMC_U_BOOT_OFFS;
+	code_len = CONFIG_SYS_MMC_U_BOOT_SIZE;
+#else
 	blklen = mmc->read_bl_len;
 	tmp_buf = malloc(blklen);
 	if (!tmp_buf) {
@@ -91,6 +95,7 @@ void __noreturn mmc_boot(void)
 	/*
 	* Load U-Boot image from mmc into RAM
 	*/
+#endif
 	blk_start = ALIGN(offset, mmc->read_bl_len) / mmc->read_bl_len;
 	blk_cnt = ALIGN(code_len, mmc->read_bl_len) / mmc->read_bl_len;
 	err = mmc->block_dev.block_read(0, blk_start, blk_cnt,
-- 
1.7.4.1





More information about the U-Boot mailing list