[U-Boot] [PATCH] I2C:Zynq: Adapt this driver to the new model

[Michael Burr]

Jagan,

I am resending as you suggest -- except I used "v2", because it seems that Heiko made the previous versions of "[PATCH] I2C:Zynq: Adapt this driver to the new model" disappear from the list. Therefore the "v1" was this: "[PATCH] I2C: Zynq: Support for 0-length register address".

However, none of that really matters much, because all of the above has been collected into the series I'm (re)sending now.

Michael Burr  //  Software Engineer II

Logic PD
T // 612.436.7273
NOTICE: Important disclaimers and limitations apply to this email.
Please see this web page for our disclaimers and limitations:
http://logicpd.com/email-disclaimer/

-----Original Message-----
From: Jagan Teki [mailto:jagannadh.teki at gmail.com] 
Sent: Tuesday, October 15, 2013 7:05 AM
To: Heiko Schocher
Cc: Michael Burr; u-boot at lists.denx.de
Subject: Re: [U-Boot] [PATCH] I2C:Zynq: Adapt this driver to the new model

On Tue, Oct 15, 2013 at 11:29 AM, Heiko Schocher <hs at denx.de> wrote:
> Hello Michal,
>
>
> Am 14.10.2013 18:25, schrieb Michael Burr:
>>
>> CONFIGs and README for driver 'zynq_i2c.c'.
>>
>>
>> Signed-off-by: Michael Burr<michael.burr at logicpd.com>
>> Cc: Heiko Schocher<hs at denx.de>
>> Cc: Michal Simek<monstr at monstr.eu>
>>
>> ---
>>
>> === This patch depends on the previous patch titled
>> === "[PATCH] I2C:Zynq: Adapt this driver to the new model"
>> === submitted 26 Sep. 2013.
>
>
> please squash this patch into the above patch, and add the
> rename of the drivers config define, and resubmit it, thanks!

And also send the series again with  I2C: Zynq: Support for 0-length
register address
patch as v3 i guess, [you missed v2 patch version name]

Will update the status on testing these on zynq boards.

-- 
Thanks,
Jagan.
--------
Jagannadha Sutradharudu Teki,
E: jagannadh.teki at gmail.com, P: +91-9676773388
Engineer - System Software Hacker
U-boot - SPI Custodian and Zynq APSOC
Ln: http://www.linkedin.com/in/jaganteki