[U-Boot] [PATCH v3] ARM: tegra: Add the Tamonten™ NG Evaluation Carrier board

[Stephen Warren]

On 10/21/2013 08:28 AM, Alban Bedel wrote:
> Add support for the new Tamonten™ NG platform from Avionic Design.
> Currently only I2C, MMC, USB and ethernet have been tested.

What changed in v3? There's no changelog here, so I don't know where to
concentrate my re-review of this patch...

> diff --git a/board/avionic-design/common/tamonten-ng.c b/board/avionic-design/common/tamonten-ng.c

> +#define MAX_I2C_RETRY		3

I don't think that's used any more.

Most of the PMU #defines aren't used either.

> +#ifdef CONFIG_BOARD_EARLY_INIT_F

I don't think any of these ifdefs are required, since the config file
hard-codes all those values. Same for #if defined(CONFIG_TEGRA_MMC)
below, and perhaps more?

> +void gpio_early_init(void)
> +{
> +	/* Turn on the alive signal */
> +	gpio_request(GPIO_PV2, "ALIVE");
> +	gpio_direction_output(GPIO_PV2, 1);
> +
> +	/* Remove the reset on the reset on the external periph */

"reset on the reset on the" ?

> diff --git a/board/avionic-design/dts/tegra30-tamonten.dtsi b/board/avionic-design/dts/tegra30-tamonten.dtsi

> +	i2c at 7000c000 {
> +		status = "okay";
> +		clock-frequency = <100000>;
> +	};
> +
> +	i2c at 7000c400 {
> +		status = "okay";
> +		clock-frequency = <100000>;
> +	};
...

Do all the carrier boards guarantee that all those I2C and SPI, and even
SDHCI busses are routed somewhere? It may be best to defer adding
status="okay" to the leaf board files, so you know there's actually
something hooked up there.