[U-Boot] [PATCH v3] usb: gadget: Fix data aborts during USB ethernet boot

Bo Shen voice.shen at atmel.com
Thu Sep 5 03:31:28 CEST 2013


Hi Joel Fernandes,

On 09/05/2013 07:55 AM, Joel Fernandes wrote:
> As seen on GCC 4.6 Linaro compiler, control_req buffer is not aligned
> on 4 byte boundaray causing data aborts in eth_setup -> conf_buf
> during dhcp boot over usb_ether. Fix the issue my aligning control_req
> buffer using DEFINE_CACHE_ALIGN_BUFFER.
>
> Tested on am335x_evm platform (beaglebone).
> Applies on 2013.10-rc1 branch.
>
> Cc: Tom Rini <trini at ti.com>
> Cc: Marek Vasut <marex at denx.de>
> Signed-off-by: Joel Fernandes <joelf at ti.com>
> ---
> v2 changes:
>   - Using DEFINE_CACHE_ALIGN_BUFFER macro for the alignment.
>   - Also fixed alignment for status_req.
>
> v3 changes:
>   - Adjusted commit message for v2 change.
>
>   drivers/usb/gadget/ether.c | 5 +++--
>   1 file changed, 3 insertions(+), 2 deletions(-)

Test on sama5d3xek board with RNDIS gadget, it still has the unaligned 
access issue.

However, I test with this patch "usb: gadget: config: fix unaligned 
access issues" from: Troy Kisky <troy.kisky at boundarydevices.com> really 
fix the unaligned access issue.

more information at: http://patchwork.ozlabs.org/patch/264151/

> diff --git a/drivers/usb/gadget/ether.c b/drivers/usb/gadget/ether.c
> index 579893c..700d5fb 100644
> --- a/drivers/usb/gadget/ether.c
> +++ b/drivers/usb/gadget/ether.c
> @@ -849,9 +849,10 @@ static struct usb_gadget_strings	stringtab = {
>   };
>
>   /*============================================================================*/
> -static u8 control_req[USB_BUFSIZ];
> +DEFINE_CACHE_ALIGN_BUFFER(u8, control_req, USB_BUFSIZ);
> +
>   #if defined(CONFIG_USB_ETH_CDC) || defined(CONFIG_USB_ETH_RNDIS)
> -static u8 status_req[STATUS_BYTECOUNT] __attribute__ ((aligned(4)));
> +DEFINE_CACHE_ALIGN_BUFFER(u8, status_req, STATUS_BYTECOUNT);
>   #endif

Best Regards,
Bo Shen



More information about the U-Boot mailing list