[U-Boot] [PATCH] doc: README.mxs: Add instruction to install 'libssl-dev'

[Fabio Estevam]

Hi Marek,

On Sun, Sep 15, 2013 at 11:03 AM, Marek Vasut <marex at denx.de> wrote:

> mxsimage is not enabled by default yet, I would like to postpone that for next
> release. But (!) it would be nice if you did start testing it so when enabled,
> it is working well.

Ok, so the issue was that I was using the mkimage provided by Ubuntu
instead of the one provided by U-boot.

There is also a typo in the directory path (arch/arm/boot/ does not exist):

With the changes below I can build u-boot.sb via mkimage method:

--- a/doc/README.mxsimage
+++ b/doc/README.mxsimage
@@ -9,12 +9,12 @@ Usage -- producing image:
 The mxsimage tool is targeted to be a simple replacement for the elftosb2 .
 To generate an image, write an image configuration file and run:

- mkimage -A arm -O u-boot -T mxsimage -n <path to configuration file> \
+ ./tools/mkimage -A arm -O u-boot -T mxsimage -n <path to configuration file> \
          <output bootstream file>

 The output bootstream file is usually using the .sb file extension. Note
 that the example configuration files for producing bootable BootStream with
-the U-Boot bootloader can be found under arch/arm/boot/cpu/arm926ejs/mxs/
+the U-Boot bootloader can be found under arch/arm/cpu/arm926ejs/mxs/
 directory. See the following files:

  mxsimage.mx23.cfg -- This is an example configuration for i.MX23
@@ -158,7 +158,7 @@ Usage -- verifying image:
 The mxsimage can also verify and dump contents of an image. Use the following
 syntax to verify and dump contents of an image:

- mkimage -l <input bootstream file>
+ ./tools/mkimage -l <input bootstream file>

 This will output all the information from the SB image header and all the
 instructions contained in the SB image. It will also check if the various

If you agree with this change, I can send a patch.

Regards,

Fabio Estevam