[U-Boot] [PATCH v5 3/8] ARM: add assembly routine to switch to non-secure state

[Mj Embd]

On Fri, Sep 20, 2013 at 4:05 AM, Peter Maydell <peter.maydell at linaro.org>wrote:

> On 20 September 2013 06:55, Mj Embd <mj.embd at gmail.com> wrote:
> > Hello Andre,
> > I need a bit clarification here, if you read the next line after the line
> > you have quoted. It clearly says that you can use a MCR to change from
> > Secure to NS in Monitor Mode
>
> No, it's not saying that, because Monitor mode is always Secure:
> this is exactly why an MCR to change SCR.NS is OK only in
> Monitor mode -- it doesn't change from Secure to Non-Secure.
> Only when you do an exception-return to leave Monitor mode
> will you drop into the NonSecure world.
>
> > "Use an MCR instruction that writes SCR.NS to change from Secure to
> > Non-secure state. This means ARM recommends that software does not alter
> > SCR.NS in any mode except Monitor mode. ARM deprecates changing SCR.NS in
> > any other mode."
>
> The text says "don't change from Secure to NonSecure by flipping
> SCR.NS". It then lays out the corollary: the only time you then can
> change SCR.NS is when it won't switch from Secure to NonSecure,
> which is when you're in Monitor mode.
>
> [MJ] Ok got your point. Then what would be the steps to return from
Monitor to Hyp mode?


> -- PMM
>



-- 
-mj